yeah! the Borg and Warner cap was the same as the OEM cap! the Accel was
opposite. Sorry just realized I didn't put a signature line on my last post.
Kurt
97 4x4 CC 5.2L ......
"Bernd D. Ratsch" wrote:
> All of the Borg Warner caps have the vent in the same spot. (I've gone
> through at least 10 sets already.)
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> To: dakota-truck@buffnet.net
> Subject: Re: DML: RE: RE: Cap & Rotor - How-To??? (Bernd...)
>
> Sorry, a bit slow on my reading, but...... Just an added tip. Don't use
> the
> vent cap as your reference point! My Accel cap had the vent 180 degrees
> from
> the stock or Borg and Warner vent location. Better to look at the bottom of
> the
> cap, at the tabs where the hold down screws come through. One is kind of
> square
> and one is half rounded. A DC design to prevent you from putting the cap on
> wrong. If you get it backwards, the cap will not seat flush on the the
> distributor base! Good luck!
>
> "Brown, Mike (CAD)" wrote:
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:52:02 EDT