Careful with the cap off? uh.. to physically change the position of the
distributor. you have to loosen up a little C clamp at the base of the
intake, which holds the distrubutor in place. As far as putting the cap on
wrong? I don't believe you can without breaknig it!
-Dester
<< I'd be careful of starting the truck with the cap off. If you don't get
the rotor back in the proper
position from where it was last set, you will mess up the firing order !!!
Check the wiring harness
to your computer. Check the coil harness wires. Check to make sure your
plug/coil wires are snapped in place
at both ends. Make sure your not getting spark by arching a screwdriver
from a plug wire to the frame when trying
to start. >>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:52:33 EDT