yes get the flowmaster 2 chamber 3"in 3" out single on the dyno 4 hp more
than open headers.i still need headers and a new cat...98dakr/t..tb, airraid
k&n,flowmasters 2 chamber 3in 3out single
>From: "David Albrecht" <patch@cdsinet.net>
>Reply-To: dakota-truck@buffnet.net
>To: <dakota-truck@buffnet.net>
>Subject: DML: Poor boy finally completed!!!
>Date: Sun, 6 Aug 2000 14:41:44 -0700
>
>Well I finally got it all installed today. I ended up just coming off =
>the flex tubing (that is attached to the air hat) with a 90 degree =
>straight 3" piece of PVC. I drilled out a hole in the bottom and =
>screwed in a small plastic nipple that has the hose barb on one end. =
>This seemed to fit perfectly with the K&N RE-0920 filter. The truck =
>does seem to perform better overall especially over 1000rpm. It shifts =
>down a little harder and quicker when you punch it when driving through =
>town. There is the noticible growl at the engine rev's up when you get =
>onto it...sounds kinda nice...almost like the exhaust is more "throaty" =
>from the inside of the cab. I guess the next move is a Flowmaster =
>muffler. I will probably get the 2 chamber version. The stock pipe is =
>2.25 inches....should I got with a 2.5 inch muffler to lessen the flow =
>even more than the 2.25 inch ones... =20
>
>Thanks...
>
>David Albrecht
>Missouri
>
>
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:53:19 EDT