RE: v-10 in a dak?

From: Chapell, Ron (RChapell@rlps.com)
Date: Thu Aug 10 2000 - 14:32:35 EDT


the only difference that I know of is that it is an aluminum block for the
viper and a cast block for the ram. I am sure that there are other
differences of which I am not aware.

Chapell

-----Original Message-----
From: Matt . [mailto:guynamedsly@hotmail.com]
Sent: Thursday, August 10, 2000 2:34 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: v-10 in a dak?

I think the engine on ebay is for a ram...
Viper v-10 is a bit different huh

----Original Message Follows----
From: AWyseGuy@aol.com
Reply-To: dakota-truck@buffnet.net
To: dakota-truck@buffnet.net
Subject: Re: DML: v-10 in a dak?
Date: Wed, 9 Aug 2000 19:18:29 EDT

They put one in when they made the Sidewinder.. I don't think it would
take
all that much effort. or near the expense that they used. move some good
electric fans to in front of the radiator.. and maybe do some mods to the
radiator support for a bigger radiator as well. Just look closely at a V8
setup.. and try to come up with about 6 extra inches on the front end.
You can use a lot of ingenuity or a lot of money; but I've thought alot
about
this one as well. Just no where near cost feasable for me right now.
Aaron
95 Dakota Sport
86 Shelby Charger Turbo

________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:53:21 EDT