Ok folks, to make sure I understand this correctly before I screw something
up. It's always the stuff that's the clearest that makes you ask the
questions. IF I were to connect this as easy as possible I would just do
the following, correct?
1) Take the two wires going to the coil and cut them about a foot before
the coil.
2) Take the green/orange that is no longer connected to the coil and connect
that to the MSD small red wire.
3) Take the black/gray that is no longer connected to the coil and connect
that to the MSD white wire.
4) Take the green/orange that is still connected to the coil and connect
that to the MSD orange wire.
5) Take the black/gray that is still connected to the coil and connect that
to the MSD small black wire.
This is without regard to the harness or new blaster coil. I just want to
make sure I understand.
TIA,
Ron
00 SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:22 EDT