It's that easy. Yes, you should reset the computer as well. Just make sure
you set the REV Limiter and Cylinder select to the correct
numbers...otherwise, you'll be fine.
- Bernd
(Running the Digital-6 for about 2 weeks now.)
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Pukeloser@aol.com
Sent: Monday, September 04, 2000 9:33 PM
To: Dakota-truck@buffnet.net
Subject: DML: MSD digital6+ question
Hey everyone,
I finally installed the DT headers and gibson exhaust, I went with the
high flow cat so the pipe is 3" from the Y pipe to the back, sounds awesome.
Anyway I am about to install the MSD digital 6+ ignition system and am
wondering if it is as easy as it looks or am I missings something. It looks
like I just attatch the + - leads to the battery and have the wire that
previously went to the now going to the MSD controller then out from the
controller to the MSD blaster HVC coil. Is that really all there is to it (
aside from the grounds and snipping the green loop wire )?
I also recall seeing someone write about resetting the computer. Is that
something I'll need to do? if so, hows it done?
Any help here would be greatly appreciated.
JOHN
'95 Dakota CC SLT 318 DT headers, Gibson exhaust, MP PCM, K&N, 3.92 (not
LSD yet)
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:26 EDT