I don't have the dimensions. You're best bet would be to compare it to the
existing holddown. Your main concern is to have the rod centered for the air hat
and short enough to miss the hood.
Doug Fedeli
Hugh Catlett wrote:
> I read thru the FAMD modification section and didn't find the dimensions.
> Can you be more specific please? There are 3 sections and two bends to the
> "S -bolt and I don't have any of the 5 dimensions mentioned. Thanx for
> replying.
> H
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@buffnet.net>
> Sent: Sunday, September 17, 2000 11:11 AM
> Subject: DML: RE: Bent Air Filter Stud 1/4-20 x 5" L
>
> > It's on the DML modifications list. Has a picture and all that shtuff.
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Hugh Catlett
> > Sent: Sunday, September 17, 2000 9:33 AM
> > To: dakota-truck@buffnet.net
> > Subject: DML: Bent Air Filter Stud 1/4-20 x 5" L
> >
> >
> > Can anyone furnish the dimensions to the Bent Air Filter Stud. I have the
> > threaded rod and a strong desire to bend it, but don't know where or how
> > much. Help Please!!!!
> >
> >
> >
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:38 EDT