About your tranny lines, they're not too tough once you figure them out... I
believe you have to push in(if I remember right), and then twist.(It took me
about 45 minutes to
figure that one out.) Good luck, I'd ditch that tranny cooler anyway, it's
pretty tiny...
Ken Keilman
----- Original Message -----
From: Jon Smith <jon@fast4x4.net>
To: <dakota-truck@buffnet.net>
Sent: Friday, September 22, 2000 9:39 PM
Subject: DML: lost my heads : )
> ok ok, I didn't LOOSE them, they're in the floor : ) just thought I'd
share
> the fact that they'll be accompanying me to the machine shop tommorrow =)
>
> update on tranny lines (if yall care): I can't get the quick connects to
> disconnect (quickly or otherwise) so I'm vetoing DC and am going to
> disconnect the line via a Benchmade brand knife ; ) and shall install
an
> external tranny cooler to replace it.
> _______________________
> Jon Smith--Raleigh, NC
> jon@fast4x4.net
> www.fast4x4.net
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:44 EDT