Hi chad,
There are a few ways to do it. if you don't want to drill any new holes,
you can run the cable across the frame to the engine compartment, and then
through one of the grommets into the cab. My choise would be to drill a hole
through the floor and run the cable right into the cab under the seat. A rubber
grommet is needed, and pep boys (or similar) has variety packs for a couple
bucks.
Chad Simon wrote:
> How does a person run antenna cable from the bed of a '99 dak to the club
> cab with bench seats without going through the sliding window. I have a new
> scanner coming in tomorrow and want to run the antenna when I get it. I
> checked and did not see any rubber gromets to feed it through. Your help is
> greatly apprecicated.
>
> __________________________________
> Chad Simon - Worldcom
> chad.simon@wcom.com v737-1430
> Service Quality Web Team - Project Manager / Web Developer
> CS&SO Information Station
> <http://www.wcomnet.com/ncsc>
-- -=Mike Kuriger 1991 Isuzu Impulse RS 1.8 2000 Dodge Durango SLT 4x4
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:55:00 EDT