Snip<Hmmmm...sounds like my old instructions. ;)
It's located on the intake manifold on the passenger side front. (Brass
Plug). If you remove/relocate it, you'll need a 1/4" NPT Pipe Plug (Home
Depot carries these) to fill the hole. Drill a 1/2" hole in your intake
tube and thread the IAT sensor in there.>
Hey, Bernd,
Per Andy Levy & with your concurrence, I'm starting with the intake,
mostly a po-boy set-up with a K&N cone located along the pass. side of the
radiator. Ok. I remove the rubber flap to let er breathe more, & I also
hafta move the IAT?!?!? Is this mandatory? What's the negative side to
leaving it (IAT) in place - running too rich & fouling the plugs?
You got a pic of where (exactly) I oughta locate the IAT ? Only 6 " from the
TB? In the solid ABS between my 'flex" elbow & clamp? Pipe dope or teflon
tape required on the threads? TIA
Bob Smith
2K Dak SY CC Sport +
3.9l; V-6: 4X4
Lund Running Boards;
Lund Vent Shades
VersaCap
Pendaliner
Silblades
Putnam Class III Tow Hitch
Ram's Head Taillight Covers
Ram's Head Receiver Light
Hella Air Horns
AutoLite 3924s
& More to come (intake's next!)
See the DAKSY at:
http://home.nycap.rr.com/daksy/
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:55:49 EDT