Jay, toss out that catalog, call up Summit Racing and order a set of the
vertical Made For You looms. These install in place of the stock valve
cover hold down bolts (some of them anywho) and keep the wires up near the
valve cover where you want them (away from heat). I think they're ~35 bux
(???)
_______________________
Jon Smith--Raleigh, NC
jon@fast4x4.net
www.fast4x4.net
'95 Dakota 4x4 318 CC auto
----- Original Message -----
From: jay & dana <jay&dana@telus.net>
To: DML <dakota-truck@buffnet.net>
Sent: Wednesday, November 01, 2000 8:12 PM
Subject: DML: sparkplugs wire looms
> I just received a catalog for sparkplug wire looms from Made for You
> Products. My question is all of the ones I am looking at say will fit
7-8mm
> wires only, unless I go to 10.5mm wires (way to big). Will the ones for
the
> 7-8mm fit the MSD 8.5 wires? The ones I am interested in are the
Butn-Snap
> separators part# 50-056 or the universal separators part# 50-156. The
> Butn-Snap separators have self locking pegs and the Universal separators
> have stainless steel hardware to attach components. I remember Bernd
saying
> something about "don't get the cool looking metal ones". But the only
metal
> parts on these are the screws that hold the plastic looms together.
> There is so much to choose from. Has anybody out there used the "Smoothie
> Wire Loom Separator Kits" from "Made for you Products"( and I know there
> is). I found out about this product on the DML and am hoping someone can
> respond to my question. The two screws that hold these separators
together
> don't constitute as bad conductivity does it? I don't want to remove my
> valve covers to attach these looms so I would greatly appreciate any
advice
> on this matter.
>
> Thanks Guys
> Jay
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:02 EDT