> I thought about this, just not sure how much it would cost. I mean the
> length of 3" pipe needed couldnt(shouldnt) cost more than $15. Possibly a
> very minimal charge for bending the pipe. It would be really nice to have
a
> 3" pipe bet up and them even ceramic coated(better temp control and
looks).
> Because of the PVC shattering thing brought up, I am going to start
> researching custom pricing on a metal tube. Especially since I live in a
> very cold area, I dont want it to become brittle and crack with the heat
of
> the engine bay. Since my Dak is a GenII using a GenIII airhat, I cannot
buy
> the 'intake' tubes, cause I would need a custom job. I am hoping to just
> take in my fabbed up piece of PVC pipe into an exhaust shop and see what
> they can do for me. Would Jet-Hot(www.jet-hot.com/index.htm) do this small
> of job?
I found a site which says on 3" tubing, Jet Hot coating will run $13 per
foot just for the outside of the pipe. For both the inside and outside of
the pipe, the cost would be $15 per foot. I imagine total Jet Hot cost for
coating a metal 3" pipe would be around $35. Now I wonder what the turn
around time would be on this small of a job. Hmmmmmm........
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:04 EDT