Go with the S&B filter versus the K&N. You will get more flow for the buck.
---------------------------------------------------
Steve St.Laurent
2000 Dakota 4.7L, CC, Soon to be Supercharged
1999 Chebby gone in 2003
1993 Suzuki Tracker (Geo) 1.6L
COMING SOON
2003 Aspiring for a V-10 GTS-R
2003 Dodge Dakota 5.7 Hemi R/T
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Kyle Kozubal
Sent: Monday, November 06, 2000 6:07 PM
To: dakota-truck@buffnet.net
Subject: DML: Intake Tubes\Measurements
I am going to replace my current PVC intake setup with a metal tube. I want
to get a prefabbed one, just not sure if the intake tubes made for GenIII
Daks will fit my GenII Dak good. I dont see whynot, since I think the GenII
Dakotas have more engine bay room. I am using a GenIII air hat pictured on
QuickD's website, with the PVC pipe intake, and a K&N #RE-0920 Cone Filter.
I am pretty sure Tony sells just to metal intake tube, but I think it is too
short and wont get close enough to my trucks grill opening.
http://www.quickd.com/intake.htm
Intense performace has a metal intake pipe also, and comes with a "ceramic
coating"
http://www.intenseperformance.com/products/intense_air/intense_air.html
Can someone/anyone measure how long either their QuickD Intake Pipe is or
how long the Intense Performance pipe is? Are there any other 3" metal pipes
on the market?
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:07 EDT