I put mine pass. fender up near the firewall (there's a cutout so you can
reach behind to run the nuts down.) I used the 3m splices as a temp fix
till I get time to do it up better (or find the accell harness thing A ma
roo)
_______________________
Jon Smith--Raleigh, NC
jon@fast4x4.net
www.fast4x4.net
'95 Dakota 4x4 318 CC auto
----- Original Message -----
From: Mike's Dakota <mikesdakota@home.com>
To: Dakota Post Message <dakota-truck@buffnet.net>
Sent: Wednesday, November 08, 2000 8:35 PM
Subject: DML: MSD SS Coil install suggestion
> I stopped by Checker today and picked up a MSD-8207 ($35). Just a couple
of
> questions about location and hookup.
> 1.)Where is the best place to mount these? I have looked at the fender
well
> by the PCM, the firewall, the stock location seems like it will put off
too
> much heat.(on the factory coil the coating is flaking off because of heat)
> I'm open for suggestions (send links to your installs if possible)
> 2.)What type of connections are you using to splice into the factory
> harness? I want to use either use bullet connectors or those little 3-M
> splices to tie it in. this way if and when I sell the truck I can swap
out
> parts easily. Are either of these methods safe?
>
> Thanks
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:11 EDT