I stopped by Checker today and picked up a MSD-8207 ($35). Just a couple of
questions about location and hookup.
1.)Where is the best place to mount these? I have looked at the fender well
by the PCM, the firewall, the stock location seems like it will put off too
much heat.(on the factory coil the coating is flaking off because of heat)
I'm open for suggestions (send links to your installs if possible)
2.)What type of connections are you using to splice into the factory
harness? I want to use either use bullet connectors or those little 3-M
splices to tie it in. this way if and when I sell the truck I can swap out
parts easily. Are either of these methods safe?
Thanks
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:11 EDT