Think i will give it a try tomorrow Bernd .
the bottom of my 14*3 should work . But i have noticed
how war the manifold stays even after a half hour not
running
Frank G
http://members.nbci.com/dakotaperf/pics/seats.jpg
--- Michael Vetere <antonio@montana.com> wrote:
> does this work for premag engines?
>
> mike
> 88 sport 4x4 V6
>
> "Bernd D. Ratsch" wrote:
>
> > Wes,
> >
> > All you really need to do is drill a 1/2" hole in
> the intake tube to install
> > the IAT sensor. The best location I found
> though...the passenger side
> > fender. You'll have to extend the wires but
> that's not a hard job at all.
> > Don't forget to grab yourself a 1/4" Pipe Plug for
> the old IAT hold on the
> > manifold. (Home Depot carries them.)
> >
> > http://lonestar.texas.net/~bernd/DakotaPics.htm -
> Check out the IAT
> > Relocation Pics
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net]On Behalf
> Of Wes Weems
> > Sent: Monday, November 13, 2000 1:56 AM
> > To: dakota-truck@buffnet.net
> > Subject: DML: Relocation of IAT sensor
> >
> > I was wondering if anyone had pictures of their
> modifications, or
> > instructions on what I wuold want to do, to
> relocate the IAT sensor to be on
> > the intake tube =)
> >
> > Wes
>
__________________________________________________
Do You Yahoo!?
Yahoo! Calendar - Get organized for the holidays!
http://calendar.yahoo.com/
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:20 EDT
