So I went to the Engine builder's today and got the flowbench results of my
heads before they were put on the motor.
These results are all at 28" of water
lift/stock/ported
INTAKE SIDE
.200/119/134.6 ---> 13%
.300/170/185 ---> 9%
.400/193.9/221.5 ---> 14%
.500/202.5/239 ---> 18%
.600/205/226 ---> 10%
EXHAUST SIDE
.200/101/103 ---> 2%
.300/128/145 ---> 13%
.400/142/160 ---> 13%
.500/153/170 ---> 11%
.600/158/175 ---> 11%
Now, all this is a Stage 1 port job which involves some pocket porting, and
cleaning up around the valves. A little bowl work was done too.
Need some opinions, I wanna make sure I got my $200 worth =)
-miggity
PROJECT 13's --> slammed 88 Dakota / 360 swap in progress!!
miggitymike@fast4x4.net
http://surf.to.Project13s
"Beauty is only skin deep, ugly goes
straight to the frame"
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:26 EDT