Daksters that have installed a FP gauge:
I finally got my FP gauge installed (had a tough time because
the '97 does not have a pressure relief valve, and had to
find fittings for a clean rig).
Problem: everything seems to work except that the gauge
doesn't show pressure. Backlight is aok. Power off and
needle sits at highest pressure marker = aok. Power on
and needle jumps to 0 = aok. Start engine and zip, needle
does not move off 0. I've tested the sender unit manually
with a hand held gauge and it shows 42 psi.
Any suggestions, opinions, guesses???
Thanks ... getting slower and slower daily = me, not the Dak.
Bob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:28 EDT