You're fine then.
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
Subject: DML: Was: Thanks everyone!! Now: Resetting the puter
Bernd D. Ratsch" wrote:
> Resetting your computer:
>
> (1) Remove the battery cable from the NEG side
> (2) Turn the key to the START position and hold for 15 seconds
> (3) Reconnect the battery cable and start engine
> (4) Drive for about 50-75 miles for the computer to "relearn"
>
> - Bernd
Ladies, Gentlemen and Roughnecks,
I didn't do step 2 after my jet chip install.......but have driven over 100
miles.
I take it that my puter has "learned" the jet chip by now?
Is it OK that I skipped #2? or should I do it over.
BTW, the butt dyno shows a nice gain with the jet chip :o)
Tanks alota
Bob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:31 EDT