If the stock coil is getting hot enough to bubble the paint...there's something
wrong. Either swap it out for a Blaster-SS, have it replaced with another OEM
coil, or try the Accell Coil.
A bad ignition system will contribute to poor performance...and misfires.
- Bernd
> Highly unlikely that it would be cause for pinging.
>
>
> ""Mike's Dakota"" <mikesdakota@home.com> wrote in message
> news:00d501c05a42$a97da8e0$96e8b718@aurora1.co.home.com...
> > I was thinking about setting it up to be able to revert to just the stock
> > ignition or just the stock coil, I figured I would set it up for now just
> to
> > run all stock or all MSD. Maybe for diagnostic purposes I will have to
> set
> > it up to do either or, it would be just a matter of getting 1 more package
> > of those molex connectors. I have the stock coil in place for a fast
> change
> > over (30 seconds) if needed. Did you notice how hot the stock coil gets?
> > Mine gets so hot the black coating on it is flaking off, bubbling and
> > cracking, not a good thing. Could it be part of the ping problem? Mine
> no
> > longer pings, runs strong.
> > ----- Original Message -----
> > From: "Ronald Wong" <ron-wong@home.com>
> > To: <dakota-truck@buffnet.net>
> > Sent: Wednesday, November 29, 2000 9:25 AM
> > Subject: DML: RE: MSD 6A and Blaste SS Install...Long post...Thanks Ron
> and
> > Chuck!
> >
> >
>
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:45 EDT