Hi Bernd
Can you buy the replacement TB gasket from any Auto Parts Dealer or do you
have to buy it from your DC Dealer? And do the TB bolts have a certain
torque that you have to tighten them to?
Thanks
Jay
-----Original Message-----
From: Bernd D. Ratsch <bernd@texas.net>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Thursday, November 30, 2000 7:05 AM
Subject: DML: RE: Rough Idle after hard acceleration
>
>Grab a TB gasket, some Throttle Body Cleaner, and remove it for a thorough
>cleaning...including the IAC post and plunger located on the back of the
TB.
>
>- Bernd
>
>-----Original Message-----
>From: owner-dakota-truck@buffnet.net
>[mailto:owner-dakota-truck@buffnet.net]On Behalf Of A. S.
>Sent: Thursday, November 30, 2000 2:11 PM
>To: dakota-truck@buffnet.net
>Subject: DML: Rough Idle after hard acceleration
>
>
>Had to get on the gas a little harder than normal yesterday in order to
make
>my exit off of the freeway. The truck downshifted and performed perfect.
>However, once I reached the redlight at the end of the exit ramp I noticed
a
>problem. As soon as I stopped the truck began to "stumble". It idled
>pretty rough, almost as if it was about to quit.
>Anything that could cause this? I'm asking due to the fact that I'm going
>to do some tune up work on it this weekend which will include an o2 sensor,
>plugs and wires, clean filter, pcv valve, and stuff like that. Is there
>anything else I should check/change?
>Also note that when I say "hard acceleration" - the truck never went past
>3000 rpm's. I know, I know, some of you all laugh at that, but I let it
>shift at it's normal point the majority of the time.
>Thanks.
>--Aaron--
>95 DSRC 4x4 V6 auto
>www.geocities.com/adakota4x4_95
>___________________________________________________________________________
_
>_________
>Get more from the Web. FREE MSN Explorer download :
http://explorer.msn.com
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:47 EDT