I have megs on mine... Not exactly what I wanted, but now have found that
they look fine.
Sam '00 RT
www.blackdakrt.com
> -----Original Message-----
> From: owner-dakota-truck@BUFFNET.NET
> [mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of Jon Steiger
> Sent: Monday, January 01, 2001 1:50 PM
> To: dakota-truck-moderator@twisted.twistedbits.net
> Subject: Re: DML: CUDA TIPS...holy $$$$$ Batman!
>
>
> hoegen@kersur.net ("Hoegen") wrote in
> <92p2vr$k2s$1@twisted.twistedbits.net>:
>
> >Just caught the price for a set of CUDA tips!!.......geez....they cost
> >more than the roll pan. Anyone know where I can find similar tips for
> >reasonable $$ to fit the 3" x 7 3/4" opening on the proglass roll pan
> >with exhaust ports?? Actually...ANY tips that would make a could fit for
> >that opening.
> >
> >Thanks all
>
>
> I told ya so! :-)
>
>
> Know anybody with a sheet metal brake and a welder? Shouldn't
> be too hard to fab something up, then send it out for chrome plating...
>
>
> --
>
> -Jon-
>
> .---- Jon Steiger ----- jon@dakota-truck.net or
> jon@twistedbits.net ------.
> | Affiliations: AOPA, DoD, EAA, NMA, NRA, SPA, USUA; Rec & UL
> Pilot - SEL |
> | '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96
> FireFly 447 |
> `------------------------------
> http://www.cs.fredonia.edu/~stei0302/ ----'
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:26 EDT