On Sat, 06 Jan 2001 21:24:47 -0800, william@hiatt.net ("William H.
Hiatt III") wrote:
>Well, THESE THINGS ARE A BITCH TO install! I need some help, where do most
>of the gauges normally sit? I know the voltage = 14, oil should = 40
>(straight up and down) (at idle) temp = varied, speed = varied, rpm = I
>idle on the mark above 500. I have a 4.7l. Gas gauge I'll just leave undone
>until my gas light comes on. MPH is being a bitch. Any tips for getting
>these things set right?
Do the mph by getting on an Interstate and working with the cruise
control until you are passing a mile marker every sixty seconds. As a
final test I passed five markers in exactly five minutes, then put the
needle on 60. I then put my tach on 2000, but since you have a 4.7 I
can't help you with that one. You have the voltage right, 14 during
normal operation. Do the oil by turning the ignition to on, but do
not start the engine. The gauge should point to 0 at that point.
Point the gas gauge to 1/8 as soon as the light comes on.
Terry Herrin
99 FR CC RT
14.425 @ 93.52, 258 rwhp
Wilmington, NC
Dakota R/T Club, Executive Board, SE Region
http://users.isaac.net/therrin/dakota.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:31 EDT