The 360 and 318 are different, BUT can be swapped if you pull the
connections and such off of the 318 unit. Thats basically the swap I did
with the unit I spoke of from Forward Motion. If I recall correctly, the
TPS, and some other electrical connections, and the injectors from the 318
were swapped over The 360 injectors were too big for the 318 even with a HP
computer. If you have both at hand, the entire swap over is less than 30
minutes.
TonyC
----- Original Message -----
From: loose wheels <1991dak@team.camaroZ28.com>
To: <dakota-truck@buffnet.net>
Sent: Friday, January 19, 2001 11:50 PM
Subject: Re: DML: Ok, Shelby question
> Will,
> I just bought a used Throttle body and intake from a local parts yard
and cleaned it up to put it on my truck when I finish getting the engine
rebuilt. I would call around to your local junk yards and see if they have a
throttle body for an 89-91 318ci(the 360 throttle body is different) sitting
around to see if it matches the mounting bolt pattern assuming it still has
the original intake. If it is the same as mine their should be four bolts:
two in front of the throttle bores offset from the two behind the bores. The
cost of a brand new unit is approx. $600. The used one I picked up for $75,
and spent about $10 on cleaning/rebuild stuff. Hey. if you can't find one,
you could buy my old one off me. just make me an offer. I'll even clean it
up for you. Anyhow I hope this helps
>
> Wes
> 91' CC 4x4 318ci
>
>
>
> _____________________________________________________________
> Free E-mail by CamaroZ28.Com - FULL THROTTLE INTERNET
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:39 EDT