Buy the universal set, and you'll have 2 wire sets (V8)
Sam '00 RT
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Alek Benedict
> Sent: Wednesday, February 21, 2001 8:35 PM
> To: dakota-truck@buffnet.net
> Subject: DML: MSD 8.5mm wires for I4? [was "RE: MSD wires> was Re: RE:
> SPARK PLUGS"]
>
>
> : The wires are thick so it is a tight fit up at the distributor.
> : It's not a
> : problem, just tight. As far as the coil wire goes, I have no
> : problems with
> : it. My distributor is at the rear of the engine compartment and
> : my coil is
> : next to my passenger side headlamp (in back of it) and the wire
> : reaches just
> : fine.
>
> I know it's really unlikely, but does anyone know if MSD makes these
> wires for the 4 cyl Daks, and if they do, where I could score some?
> I've searched their site [though not thoroughly] and haven't had much
> luck.
>
> --
> Alek Benedict with a techno beat.
> alek@earthling.net
>
> "i'm sittin' in the corner i can feel the weight
> of my head on top my spine
> there's nothing to be scared of once you've
> seen the light, reflecting through the screen
> a eudaemonistic life composed of tar and nicotine"
> - Fat Mike, NOFX
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:59:23 EDT