Huh?! You can't cut plug wires and splice them. Most wires come a little
longer than original stock but should be okay. In any case, MSD 8.5mm super
conductors is what I'd opt for.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile (URL follows)
http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of WOT or waiting at a
Red
Sent: Wednesday, February 21, 2001 11:46 PM
To: dakota-truck@buffnet.net
Subject: DML: Plug wires
Hey guys I need help with this.
I just purchased new plug wires, Mopar from the dealer. I know I paid too
much. When installing them, the first one fit fine. The second one was way
way too long so I had to cut out a section and splice it back together
again. Then I noticed the next wire was way way too short. I had to cut it
and put the bit of wire from the other one in the middle. Well any way all
but two of the wires in the set were the wrong length and needed to be
modified. The dak run like crap now.
Where can I get the correct wires if Mopar can't even make um? ;-)
Patrick O'Day
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:59:23 EDT