Re: Re: 4.7 Mopar computer, HP gains to date

From: Arnoldo Silva (silva@rio.bravo.net)
Date: Wed Feb 28 2001 - 20:03:13 EST


hey mat you have any pics of your truck thanks
arnold

----- Original Message -----
From: <WMBARRET@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Wednesday, February 28, 2001 4:41 PM
Subject: DML: Re: 4.7 Mopar computer, HP gains to date

> Al, The "butt" dyno , it was a slight increase, but on the chassis dyno it
gave an honest 9 hp @ the RW, and 9 FT/lbs TQ @ the RW. It should be noted
this PCM was bolted on after my air-intake, and Flowmaster cat back system.
My dyno results look like this:
> 1. Baseline (never did run it stock)
> 2. removed air hat, and air box, pulled with an open TB, that was the only
mod. pulled 208hp, and 285 tq
> 3. Added a 3" cat back flowmaster system($170), custom air intake in
place. pulled 209.9 hp, and 285 tq
> 4. Added the Mike Leach Custom PCM($450) (5 degrees adv., 5% fuel
increase. Pulled 216.5 hp, and 292.8 tq
> 5. Added Hughes Engines Stage I 65mm TB ($75). No dyno results, but track
results showed a tenth gain in 1/4 ET. Estimated HP at this point 225 hp +-
> 6. Coming soon: Hughes Engines Stage I 68mm TB ($150+75), will be here
next week, should see an additional 3-5hp +-. Closing in on 230 hp @ the
rear wheels or, about 270 hp at the crank shaft+-.
>
> CHASSIS mods: Doetch Tech shocks, Hoosier Slicks, Lowered 2" in rear,
Caltracs just recently installed.
>
> Matt
>
> In a message dated Wed, 28 Feb 2001 3:37:38 PM Eastern Standard Time, Al
& Jeanna Figols <ALJF@mhonline.net> writes:
>
> << Did you notice much of a difference with your reprogramed PCM? I have
> an automatic so I probably wouldn't gain as much power as your manual
> trans Dakota.
> Al
>
> WMBARRET@aol.com wrote:
> >
> > Don't wait for Mopar, call Mike Leach, he writes the software for Mopar!
The Mopar PCM will have 5 degrees advanced timing, and thats what Mike did
to my PCM, there is more advance to be had, Leach can put as much in there
as you want! I wish I had asked for more advance.
> >
> > Mike Leach & CO
> > 1443 West Collins Avenue, Orange, CA 92867
> > (714) 639-5220
> >
> > Matt Y2K-HEMI
> > '00 RC 4.7L 5 spd
> > 14.23 @ 94.49
> >
> > In a message dated Wed, 28 Feb 2001 10:08:40 AM Eastern Standard Time,
RobertE.Tucker@gunter.af.mil writes:
> >
> > << It is not released yet. You can get a custom flash on your system.
> >
> > SSgt Robert E Tucker
> > Email Administrator
> >
> > -----Original Message-----
> > From: Al & Jeanna Figols [mailto:ALJF@mhonline.net]
> > Sent: Wednesday, February 28, 2001 7:45 AM
> > To: Dakota list
> > Subject: DML: 4.7 Mopar computer
> >
> > Has anyone tried the Mopar HP engine computer for the '00-up 4.7L?
> > Al
> > >>
> >>
>
>
>
>



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:59:35 EDT