No...it works in conjunction with the factory (or aftermarket) PCM.
AND...you can use your MSD along with it (or Jacobs or Accel). I'm running
my Digital-6+ with it.
This is a TIMING CONTROLLER only. No boost, no fuel, no other
controls...just timing. What you're thinking of is the Felpro Computer that
replaces (and works with) the factory PCM. (Ron Merx has on on his 15#
Boosted R/T.) Very nice setup as well...but out of the normal price range.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
Subject: Re: DML: Re: Received the SuperChips ICON
Bad Ass, does this take place of the factory computer? I really wanna ditch
that bad boy, Accel makes a nice setup (I know I guy running one ona blown
R/T) controls the injectors, one O2 sensor input, jsut really nice, very few
wires (lot less than stock (so it looks really good) and it's got hookups
for
pressure sensors (for boost) to adjsut to amount of boost without having to
be "programmed" you set on level and then how to change air fuel ratio
acording to boost and it handles it all on it's own, VERY NICE, very
expensive I think he said like $3000 or somthing, wasn't really paying to
much attention, too busy drooling over his dakota (four link rear coilovers
in all 4 corners, and also huge slicks tucked perfectly into te rear, look
totally stock (other than lowered) bad ass) Oh well nuf babblin...
Greg
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:59:57 EDT