yeah i have taylor wires on mine..no solid core..
----- Original Message -----
From: "Ronald Wong" <ron-wong@home.com>
To: <dakota-truck@buffnet.net>
Sent: Saturday, March 24, 2001 3:55 PM
Subject: DML: RE: Re: RE: Installed the MSD
> You should set your gap at .005 over factory specs and see how that does.
> Some people set theirs to .010 over factory specs. I don't know whether
the
> Jacobs plug wires are considered solid core wires or not. Jacobs
specifies
> them as metal core wires. Here's what MSD has to say about solid core
> wires: [Note: Solid Core spark plug wires cannot be used with an MSD
> Ignition.] That's part of the installation instructions for the 6A.
>
> Ron
> 00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
> For modifications see my DML Profile (URL follows)
> http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
>
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> Sent: Friday, March 23, 2001 1:35 PM
> To: dakota-truck@buffnet.net
> Subject: DML: Re: RE: Installed the MSD
>
>
> Thanks bernd. will i need to increase the gap at all? since it is a stock
> coil?
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@buffnet.net>
> Sent: Saturday, March 24, 2001 3:05 PM
> Subject: DML: RE: Installed the MSD
>
>
> > Give it a little bit, but the "zing" should be there...a little bit.
Try
> to
> > notice the idle quality, acceleration (smoother or not?) and MPG in the
> long
> > term.
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> > Sent: Friday, March 23, 2001 2:53 PM
> > To: DML
> > Subject: DML: Installed the MSD
> >
> >
> > Well i put the MSD in , wired the factory coil into it.
> >
> > Ok, now where is the ziiing at? It ran pretty much like normal, no Check
> > engine light or anything yet. Too early to tell yet?
> > Any other MSD stories or advice?
> > I put in the 6A box.
> >
> > Paul
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:25 EDT