Matt,
Ill have flow data by Thursday.. And hopefully some dyno data to sort
through as well!
Bruce
----- Original Message -----
From: <WMBARRET@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, March 27, 2001 4:49 AM
Subject: Re: DML: 4.7 69mm TBs first steps..
> Bruce, what is the flow data on this 69 mm TB you are using on Jason's
Truck??
>
> Thanks
> Matt Y2K-HEMI
>
>
>
> In a message dated Mon, 26 Mar 2001 12:18:17 PM Eastern Standard Time,
"Bruce Bridges" <bbridges@flometrics.com> writes:
>
> << Thanks to Jason M for offering his clean 4.7 CC for testing the first
F&B
> 4.7 Prototype 69mm TB! So far results are inconclusive. After bolting it
up
> we experienced some prototype teething pains with a sticky shaft. Once
that
> was corrected we went to the track for some real time testing... The track
> was packed and the humidity was 100%...Temps were in the 60s. Every one
was
> having a hard time hooking up... My truck runs a consistent 2.2 60ft at
this
> track without me trying.. my best Sat was a 2.365...very slippery. Jasons
> 60ft varied between a 2.4 and a 2.7 I think...his Best E/T was a 15.7 But
> his top speed was right around 89 mph... After 4 runs (two with the 69mm
and
> two with the stock TB) we couldnt make heads or tails of the
> data...Hopefully the dyno will be easier to get a good test on... We will
> see on Tuesday!
> Bruce
>
> >>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:30 EDT