check the bulbs for continuity?
______________________
Jon Smith--Raleigh, NC
www.fast4x4.net
jon@fast4x4.net
344hp/424tq
ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
-
-Well let me tell you my experiences...
-
-My fog light switch went out last Thursday. I already decided to make my
-fogs into Daytime Running Lights. So here is what I did...
-I used my stock for fuse in the Power Distribution Center. And
-also used my
-stock relay. However I changed the wiring behind it. I have a constant
-power into the relay. I have a wire to my switch inlet in the fog relay
-into the switched outlet of the relay of the fuel pump. OK then I have the
-ground to the chassis and the load (fog lights) running to a splice. One
-goes to the right fog lamp and one goes to the left. Then I have a ground
-from each fog light to the chassis.
-
-OK, now I tested the outlets to the fog lights (with out the bulbs) with a
-volt meter. From the (-) of the volt meter to the chassis and the (+) of
-the volt meter to the (+) of the fog outlet. I tested both fog outlets and
-both were 14.2 volts. I then put the (-) of the volt meter to the (-) of
-the fog outlet and the (+) to the volt meter to the (+) of the fog outlet.
-I did this for both and both came up with 14.2 volts.
-
-When I plug my fog light bulbs in they don't light. What am I doing wrong?
-What did I leave out? Please dumb is down for me please :)
-
-Thanks so much
-
-Tim Althoff
-http://www.angelfire.com/oh3/yllw/dkta.html
-99 Solar Yellow RC V-6 Manual
-
-
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:33 EDT