Yes, it'll work fine. BUT, beware, the 68mm TB only flows about 10-20 cfm more than the 65mm, according to Hughes Engines, who I had flowbench both a 65mm and a 68mm TB.(I'll double check these figures, I believe it was about 15+-)
Matt Y2K-HEMI
'00 RC 4.7L 5spd
14.23@94.49
In a message dated Fri, 6 Apr 2001 8:41:25 PM Eastern Daylight Time, "Wxman" <Wxman@hotmail.com> writes:
<< Has anyone actually made this swap? I know the 2001 TBs are 68mm vs the
65mm that came in the 2000 models. Is everything else the same for a direct
bolt-on replacement? I have heard yes, but never from anyone who has
actually done it. If it will work I will make the swap and post before and
after G-tech numbers.
Thanks
Wxman
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:58 EDT