RE: IAT Adjuster Install...

From: Bernd D. Ratsch (bernd@texas.net)
Date: Wed Apr 18 2001 - 01:05:50 EDT

Next message: Michael Clark: "Re[2]: UPDATE: V10 Ebblems"
Previous message: jdharmon@earthlink.net: "DACUDA parts available"
In reply to: geoff@centrifugepartners.com: "IAT Adjuster Install..."
Next in thread: steve preston: "Re: Re: Re: When are timing chains supposed to start getting noisy?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

(3) Connect the two enclosed MALE connectors to the IAT Sensor connector.
(4) Connect the two enclosed FEMALE connectors to the wires in the harness
running to the PCM.
(5) Connect the IAT Adjuster harness to the connectors and your done. (You
can close the hood now.)

-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of
geoff@centrifugepartners.com
Sent: Tuesday, April 17, 2001 8:01 PM
To: dakota-truck@buffnet.net
Subject: DML: IAT Adjuster Install...

I just installed it, but am checking before I start it.

on the IAT adjuster harness-- what color goes to red or blue on the IAT
sensor (blue or red on the sensor, red black green or yellow on your loom).
Also, witch goes to witch on the PCM side.?

Thanks,
-geoff

Next message: Michael Clark: "Re[2]: UPDATE: V10 Ebblems"
Previous message: jdharmon@earthlink.net: "DACUDA parts available"
In reply to: geoff@centrifugepartners.com: "IAT Adjuster Install..."
Next in thread: steve preston: "Re: Re: Re: When are timing chains supposed to start getting noisy?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:05 EDT