Yup.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of jay & dana
Sent: Wednesday, April 18, 2001 5:20 PM
To: dakota-truck@buffnet.net
Subject: DML: Re: RE: IAT relocation time
I plan on installing it in the K&N intake tube, just wondering about the
location relating to the filter and the airhat, if it matters. Also I don't
understand, a 1/2 inch hole to mount it but only a 1/4 inch pipe plug to
fill the existing hole in the manifold?
TIA
Jay
>You'll need a 1/4" pipe plug from Home Depot. Put the IAT sensor either in
>the fender well or intake tube. (Requires a 1/2" hole to mount it.)
>
>- Bernd
>Two questions though, I know that they have been mentioned before but
>sometimes
>my delete goes off by itself 8^).
>1: When plugging the old hole in the manifold (97, 318) what type and
>size of plug
> do I need, and should I use something like teflon tape on the
>threads or ?.
>2: On the K&N Gen II, where should I relocate it to ( in the tube)? How
>far up from
> the cone filter and how far down from the TB "airhat" on the FIPK?
>
>Thanks as always Guys
>
>Jay
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:06 EDT