About 4-6" upstream from the TB is perfect.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of jay & dana
Sent: Thursday, April 19, 2001 5:02 PM
To: dakota-truck@buffnet.net
Subject: DML: IAT relocation time,Attn: "the other" Will
Thanks for explaining this for me Will, now I understand. Learn something
new everyday.
Now if I only knew where to place this sensor in the intake tube. Like
maybe 6 inches upstream
from the K&N filter, 6 inches downstream from where it attaches to the TB,
or ? Then I'm all set.
Thanks again
Jay
<< I plan on installing it in the K&N intake tube, just wondering about the
location relating to the filter and the airhat, if it matters. Also I don't
understand, a 1/2 inch hole to mount it but only a 1/4 inch pipe plug to
fill the existing hole in the manifold?
TIA
Jay >>
A standard thread bolt is uniform in diameter. A NPT or pipe thread plug is
tapered. You will notice this when you buy the plug. NPT's are also
measured totally different from standard bolts, etc...
The other Will
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:06 EDT