MArk,
I'll check my reference material tonight for you. It's been a while since I
read the article, but I think they mentioned a place on each coast. It
wasn't cheep, I remember that! I believe flowing an intake was like $600.
Rich - Ashburn, VA
-----Original Message-----
From: Mark Kuzia [mailto:flyboy01@mediaone.net]
Sent: Monday, April 23, 2001 1:42 PM
To: dakota-truck@buffnet.net
Subject: DML: Anyone know where I can get extrude honing?
Anyone know where I can get extrude honing? I am looking to have my intake
done soon.
Mark Kuzia
flyboy01@mediaone.net
http://people.mw.mediaone.net/flyboy01/home.html
1995 Dakota 13.79 @ 102.45 mph
360ci, 5-spd, 4.11 LS(8 3/4 [3.90 SG] coming soon)
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:08 EDT