At 06:40 PM 4/26/2001 -0500, you wrote:
>You're pinging that bad from a $200 PCM??? Something isn't right.
>
>- Bernd
I found a old post of yours about pinging...
This weekend I'll put in a set of 3923s and a 180* thermo
What is the right way to route the plug wires? Not crossing each other,
but what about other wires n such.
I haven't got around to replacing my O2 sensor yet, but will try again this
weekend.
Also my timing chain tick has gotten slightly worse in the past couple of
weeks. I'll probably get it replaced soon. Actually I was looking over
the archives earlier with some of your posts about the double roller and
the tensionor. Can you give me the part numbers if you have a chance and
they are handy.
anything else I should look into.
mm
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:12 EDT