Use the thin tips from the DVOM and insert the "+" probe into the sleeve
around the middle MAP terminal. That's how I used to (and still do) test
them.
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
Subject: DML: Testing the map sensor
Hi, I'm trying to diagnose poor gas milage on my 95 dak 3.9 and I found
these instructions on the Mitchell Repair Info. DVD at school:
it says where the MAP sensor is... I check the voltage from the center
termainal with the ignition switch on I should get 4.0-5.0 volts with the
engine runing it should be 1.5-2.1 volts. The test must be performed with
the connector in place. How can I test the voltage of the center terminal
if there is no way to get the dvom probes into the wire?
Thanks,
Geoff
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:13 EDT