Re: FW: Dyno @ Carlisle WAS: Post from Matt Barret about Bruce's TB

From: WMBARRET@aol.com
Date: Mon May 07 2001 - 10:21:27 EDT

Next message: John Clawson: "IAT Adjuster...Attn. Bernd."
Previous message: Jon Smith: "Re: IAT Adjuster...Attn. Bernd."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

$75 for 3 pulls, plus possible magazine coverage ;) !!

Matt Y2K-HEMI
'00 RC 4.7L 5 spd 3.92
14.23 @ 94.49

In a message dated Mon, 7 May 2001 9:45:08 AM Eastern Daylight Time, "Barret, Matt" <MATT_BARRET@earthtech.com> writes:

-----Original Message-----
From: Andy Levy [mailto:andylevy@bigfoot.com]
Sent: Thursday, May 03, 2001 7:23 PM
To: Y2KDakuda@aol.com
Subject: Re: DML: Dyno @ Carlisle WAS: Post from Matt Barret about
Bruce's TB

Dyno at Carlisle? What's the cost, usually? By that weekend I should
have enough goodies on the truck to warrant a dyno pull.

Y2KDakuda@aol.com wrote:
> I nice piece of engineering work, that I'd highly recommend. I'll have it
> on the dyno in July, at the Chrysler National @ Carlisle PA.
>
> Thanks Bruce ! you da Man !
>
> Matt Y2K-HEMI
> '00 RC 4.7L 5 spd 3.92
> 14.23 @ 94.49

-- 
-andy
http://home.twcny.rr.com/andylevy/ --- andylevy@bigfoot.com 
----------------------------------------------------------------
Remember, amateurs built the ark.  Professionals built the Titanic.
----------------------------------------------------------------
 >>

Next message: John Clawson: "IAT Adjuster...Attn. Bernd."
Previous message: Jon Smith: "Re: IAT Adjuster...Attn. Bernd."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:26 EDT