You can do it. I can help. You do it in two parts. Each part is very thin
and covering 1/2 of the wooden model. Then you glue them together and
laminate over that.
----- Original Message -----
From: <Puddlestompa@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Friday, May 25, 2001 9:26 AM
Subject: Re: DML: Re: custom intake
> In a message dated 5/25/2001 9:14:31 AM Pacific Daylight Time,
> dakatack@home.com writes:
>
> << Hey can I help? Homebase is selling pipe cheep this
> weekend. >>
> Sure, this is my dilemma, I was going to make a wooden model for the
intake
> tube and then wrap the fiberglass around that, but I am afraid I will not
be
> able to get the wood out, especially since the pipe will be larger in the
> middle than at the two ends. Maybe I will just have to stick with a pipe
> tube and a fiberglass heat sheild.
>
>
> Aaron
> Vancouver, Wa
> 98 2WD 2.5L 4cyl RC
> http://www.hometown.aol.com/puddlestompa/mydak.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:34 EDT