"Dave and Charlene" <DOHCTurboIII@sympatico.ca> wrote:
: I installed one of these on a Dak RT on tuesday. Replaced a stock intake. It
: already had MP cam, 1.6 roller rockers,MP headers ,MP PCM,MP cold air,Cat
: back exhaustand SMR convertor. Made quite a difference. Alot more bottom
: end,steadier idle,alot more top end, and slighly reduced midrange.Only real
: problem I found was couldn't use factory style rubber end seals, and they
: wouldn't compress far enough,as the intake sat down further so had to use
: good silicone.Hes going to run it this weekend. Dave St.Louis
Dave,
Could you clarify what you mean about the end seals? If I'm reading
your message right, the end seals held the intake up in the air such
that the intake to head gaskets didn't seal properly? Did you use the
cork ones, or just the silicone?
---Jon-
.---- Jon Steiger ------- jon@dakota-truck.net or jon@jonsteiger.com -----. | Affiliations: AOPA, DoD, EAA, NMA, NRA, SPA, USUA; Rec & UL Pilot - SEL | | '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96 FireFly 447 | `------------------------------------------ http://www.jonsteiger.com ----'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:46 EDT