Head gasket thickness

From: Mark Kuzia (flyboy01@mediaone.net)
Date: Sun Jul 01 2001 - 12:57:50 EDT

Next message: tmfu: "FW: neon Petition..."
Previous message: tmfu: "RE: Carlisle route (Greg)"
Next in thread: Jon Smith: "Re: Head gasket thickness"
Reply: Jon Smith: "Re: Head gasket thickness"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Does anyone know what the compressed head gasket thickness is for the magnum
engine's? I'm checking the piston to valve clearance and need to know so I
can add it to my measurements. Thanks

Sam South
sawcut64@mediaone.net
http://people.mw.mediaone.net/sawcut64/home.html

Next message: tmfu: "FW: neon Petition..."
Previous message: tmfu: "RE: Carlisle route (Greg)"
Next in thread: Jon Smith: "Re: Head gasket thickness"
Reply: Jon Smith: "Re: Head gasket thickness"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:03 EDT