> It was installed that way,more less. the bearings are a tight fit. you will
> need a install tool to put it in correctly. REMEMBER the holes must line
> up,so the oil can flow correctly, if the hole lines up now, i would leave
> it. you dont want half a hole to show, That would be BAD..
> ----- Original Message -----
> From: "Michael Clark" <mike@mikesdakota.com>
> To: <dakota-truck@buffnet.net>
> Sent: Friday, August 17, 2001 11:49 PM
> Subject: DML: cam bearing
>> Anyone know the best way to fix this:
>>
>> http://www.mikesdakota.com/360/bearing.jpg
What's the best way to fix this, do it yourself or take it to a shop?
I have no bearing installer tools or would I know what to do with
them if I did have some....
--Mike
www.mikesdakota.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:28 EDT
