http://www.made4uproducts.com/
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile (URL follows)
http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of MAGNUM96@att.net
Sent: Tuesday, August 21, 2001 9:20 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: Re: RE: RE: Made For You wire looms
does the company HAVE A web site???
Chris
www.geocities.com/chrisdakota.geo
> Rich, which ones were melting? Are you running JBA or MP headers? I've
> got problems with the rear most (lower right corner valve cover bolt hole)
> loom on the driver's side. It gets WAY too hot, but it's due to the ram's
> horn design of the JBA header (#7 cyl)
>
> Aint no big deal to me, shoot an email and have a fresh set 4 days later
:)
> No questions asked, they were very appologetic that it failed, and don't
> require the old ones back! I give them and K&N both a 10 in customer
> service.
> __________________
> Jon Smith
> Raleigh, NC
> '95 CC 318 4x4 auto
> 344rwhp/424tq
>
> I believe Mike Clark is using them also. I use to have them for about a
> year until they melted. They couldn't take the engine heat for some
reason.
> (Guess I just have a hot 318.) :'B Pulled them out and installed a set
of
> Morosso's. Noticed they were even starting to give way from the heat.
> Guess they'll need replaced soon too!
> Rich - Ashburn, VA
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:31 EDT