In a message dated 8/26/2001 7:00:48 PM Central Daylight Time,
kwreimer@email.msn.com writes:
<< Yeah, drill the damn thing out with a drill bit the diameter of the bolt
then re-tap the hole to accommodate a new bolt of larger diameter?? whatcha
think? >>
Drill the hole to just before you reach the threads.. and reach in with a
pick to pull the remains out of the threads or then use a larger easy out..
once there is very little left of the bolt; the remains will have much more
give to them for pulling loose.
Aaron W in AL
94 RC WS 2.5L 5spd
95 RC Sport 2.5L 5 Spd
86 Shelby Charger Turbo
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:34 EDT