At 10:25 PM 8/31/01 -0700, you wrote:
>I didn't use a case, just the optima. Had to turn it on it's side so the
>posts
>face forward and the battery is smaller vertically. I just used 2 gauge
>copper
>wire from Home Depot, 50cents/ft. Works great. You can run the power
>line down
>through the wheel well then INTO the frame and it pops out of the frame about
>12" before where I put the battery. I didn't bother with the sensor, I
>figured
>it would throw codes of "Too Cold" If I moved it too.
Thanks, Jay. I had not come across anywhere about running the cable into
the frame.
Good to know.
I'm also planning on putting the optima on its side. I decided to go with
a box because
of the salt that used up here in the winter and because the NHRA rule
requiring a box
was a bit vague and I decided to play it safe. Thanks again.
Bob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:43 EDT