HA!
Found it!!
A long time ago, my Jet-II Chip messed up a pin on the PCM. #C1 (Coil
Driver). The pin was shoved too far back and wasn't making any contact
with the connector. Luckily, there was enough to pull the pin back out.
She fired right up! :)
WHEW
Thanks for the folks who responded though.
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Bernd D. Ratsch
Sent: Saturday, September 01, 2001 2:36 PM
To: dakota-truck@BUFFNET.NET
Subject: DML: RE: RE: Need some help for ideas
I'm working on that idea...
What happened was that the SuperChips box got wet inside and shorted out
(my bad). I dried it and was able to "limp" the truck home.
Fortunately, that's all she had left in her. I received the replacement
SuperChips ICON overnight (this AM) and replaced it immediately. Still
no spark...so I removed it and went back to the factory wiring (no
SuperChips or MSD).
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Ronald Wong
Sent: Saturday, September 01, 2001 2:31 PM
To: dakota-truck@BUFFNET.NET
Subject: DML: RE: Need some help for ideas
You know, if you blew ignition fuse you'd better check the wiring and
make sure nothing fried or a big, fat short.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile (URL follows)
http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of Bernd D. Ratsch
Sent: Saturday, September 01, 2001 12:15 PM
To: dakotart@yahoogroups.com
Subject: DML: Need some help for ideas
Ok, here's the scenario: No Spark
Bypassed MSD and SuperChips ICON and reinstalled factory coil, checked
ASD Relay, Fuse box (had two blown fuses - Horn and Ignition - Replaced
them as well), and still no spark.
Checked Distributor rotor, cap, connections, trigger plate, all check
out fine.
Going through the trouble shooting guides online (FSM) but nothing fixed
yet (still working on it).
Anyone got any ideas?
Thanks,
- Bernd
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:43 EDT