I'm still a little lost. Am I removing the bolt on the steering shaft
closest to the firewall or the steering box?? A couple people said remove
the 15mm bolt....both bolts on mine are 1/2". And what coupler clip am I
supposed to rotate?
--Aaron--
95 DSRC 4x4 V6
www.geocities.com/adakota4x4_95/
>From: "Bernd D. Ratsch" <bernd@texas.net>
>Reply-To: dakota-truck@buffnet.net
>To: dakota-truck@buffnet.net
>Subject: DML: RE: Re: Anyone have a 95 (or GenII) FSM?
>Date: Sun, 02 Sep 2001 08:15:14 -0500
>
>
>Disconnect battery ground cable, then raise and support vehicle.
>Remove skid plate, if equipped.
>Remove lower starter mounting nut and lock washer from front of vehicle
>with long extension.
>Lower vehicle and remove intermediate steering shaft coupler bolt, then
>rotate coupler clip on steering shaft and slide upper half of shaft to
>rear.
>Remove upper starter mounting bolt and move starter forward until it
>clears lower mounting stub, then lift starter upward to access wiring
>connections.
>Remove battery and solenoid lead connector nuts, then remove starter.
>Reverse procedure to install, noting the following:
>Torque starter mounting bolts to 50 ft. lbs.
>Torque starter mounting nuts to 20 ft. lbs.
>Torque battery lead terminal nut to 90 inch lbs.
>Torque solenoid lead terminal nut to 22 inch lbs.
>Torque steering shaft coupler bolt to 35 ft. lbs.
>
>-----Original Message-----
>From: owner-dakota-truck@buffnet.net
>[mailto:owner-dakota-truck@buffnet.net] On Behalf Of Jon Smith
>Sent: Sunday, September 02, 2001 12:10 AM
>To: dakota-truck@buffnet.net
>Subject: DML: Re: Anyone have a 95 (or GenII) FSM?
>
>
>Aaron, email me off list tommorrow and i'll look it up... FSM is in the
>truck and it's now time to check my eyelids for holes :)
>__________________
> Jon Smith
> Raleigh, NC
>'95 CC 318 4x4 auto
> 344rwhp/424tq
>----- Original Message -----
>From: "A. S." <adakota4x4@hotmail.com>
>To: <dakota-truck@buffnet.net>
>Sent: Sunday, September 02, 2001 1:19 AM
>Subject: DML: Anyone have a 95 (or GenII) FSM?
>
>
>I need someone to look up how to disconnect the steering shaft on a 95
>so I can replace the starter. I think I know how, but I don't want to
>mess anything up. It seems you only have to do this on the 4x4's. If
>someone could look this up for me and explain it (or even scan the page)
>it would help me out a lot.
>
>Thanks!!
>--Aaron--
>95 DSRC 4x4 V6
>www.geocities.com/adakota4x4_95/
>
>_________________________________________________________________
>Get your FREE download of MSN Explorer at
>http://explorer.msn.com/intl.asp
>
>
>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:43 EDT