hmm, o.k so you read the voltage, then what? is there a dial to set it? what
do you adjust, I am completly missing something here????
Punch
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1998 Dakota CC V6, Deep Amethyst, K&N Homebrew Intake,
Gutter Guard Grills, Dynomax Cat Back Exhaust,
Autolite 3923's.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
*In the near future: Jet stage 2, Billet TB, 180Dg. Thermo, energy
suspension bushings,
Hotchkis sway bars, BFG A/T KO 235/75/15, AirRaid intake, Leer Cap, Spray
in bedliner,
MTX Thunderforms.
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@buffnet.net>
Sent: Friday, October 26, 2001 12:58 PM
Subject: RE: DML: TPS Sensor Modification online with instructions
> You read the voltage from the middle connector on the TPS.
>
> The other lead from your DVOM is to ground.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net] On Behalf Of Aajaynefour@cs.com
> Sent: Friday, October 26, 2001 11:53 AM
> To: dakota-truck@buffnet.net
> Subject: Re: DML: TPS Sensor Modification online with instructions
>
>
> Bernd,
>
> Is the initial voltage setting of .7-.8 the same on 4.7s? Also, do you
> make
> the voltage reading from the middle wire to ground?
>
> Thanks,
> Andrew
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:22 EDT