----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@buffnet.net>
Sent: Friday, October 26, 2001 1:42 PM
Subject: RE: DML: TPS Sensor Modification online with instructions
>
> Punch,
>
> You watch the voltage on the TPS with the Key ON/Engine OFF. Once
> you're right about .7v, tighten down the screws and check it again to
> make sure the voltage didn't move too much (+/- .05v is ok). You adjust
> the voltage on the TPS by moving the actual sensor...that's why the
> inserts are drilled out..to allow for adjustment.
understood now, thanks!
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net] On Behalf Of Punch
> Sent: Friday, October 26, 2001 12:36 PM
> To: dakota-truck@buffnet.net
> Subject: Re: DML: TPS Sensor Modification online with instructions
>
>
> hmm, o.k so you read the voltage, then what? is there a dial to set it?
> what do you adjust, I am completly missing something here????
>
>
> Punch ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> 1998 Dakota CC V6, Deep Amethyst, K&N Homebrew Intake,
> Gutter Guard Grills, Dynomax Cat Back Exhaust,
> Autolite 3923's.
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> *In the near future: Jet stage 2, Billet TB, 180Dg. Thermo, energy
> suspension bushings, Hotchkis sway bars, BFG A/T KO 235/75/15, AirRaid
> intake, Leer Cap, Spray in bedliner, MTX Thunderforms.
> ----- Original Message -----
> From: "Bernd D. Ratsch" <bernd@texas.net>
> To: <dakota-truck@buffnet.net>
> Sent: Friday, October 26, 2001 12:58 PM
> Subject: RE: DML: TPS Sensor Modification online with instructions
>
>
> > You read the voltage from the middle connector on the TPS.
> >
> > The other lead from your DVOM is to ground.
> >
> > - Bernd
> >
> > -----Original Message-----
> > From: owner-dakota-truck@buffnet.net
> > [mailto:owner-dakota-truck@buffnet.net] On Behalf Of
> > Aajaynefour@cs.com
> > Sent: Friday, October 26, 2001 11:53 AM
> > To: dakota-truck@buffnet.net
> > Subject: Re: DML: TPS Sensor Modification online with instructions
> >
> >
> > Bernd,
> >
> > Is the initial voltage setting of .7-.8 the same on 4.7s? Also, do
> > you make the voltage reading from the middle wire to ground?
> >
> > Thanks,
> > Andrew
> >
> >
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:22 EDT